27 Level: Signal level control for the frequency-corrected line output; it is used to match
the amp’s signal level at the Line output to the mixing console or recorder’s input.
28 Overload: This LED denotes the Line output is overloading; in this case,
reduce the signal’s level via the Level control.
29 Line Out Frequency Compesated: The frequency-corrected, balanced Line output jack
(XLR; Pin 2 and 3 signal, Pin 1 = N.C. ). This signal can be routed directly to a mixing console or
a recording unit. The line out is located post poweramp in the signal chain, so ensure the poweramp
is activated and a load is connected to one of the output jacks.
The Line Out’s output level is influenced by the following factors: By the input level (Gain), the Volume
control setting for the Lead channel, to some degree by voicing control settings, and by the Master
volume level. First dial in the desired sound combination at the front panel. Then adjust levels at FX
devices or signal processors (if connected). Now use the Level control to adjust the Line level. The Line
output is not overloaded until the Overload LED illuminates brightly and continuously. You can push the
level up to this point to match a mixing console or recorder’s input level requirement. Use the respective
device’s input sensitivity or gain control to fine-tune level adjustments.
Technical Data:
Rated power: approx. 100 watts at 4, 8 or 16 ohms.
Tubes: V1 (input-tube): ECC 83 / 12AX7, FQ selected;
V2, V3: ECC 83 / 12AX7, selected;
V4: ECC 83 / 12AX7, standard;
V5 - V8: 5881(6L6GC) matched set.
Fuses: external: 2,5 AM (medium) at 230 Volts;
5 AM (medium) in the 100 and 120 Volts models.
internal: 3,15 AT (slow) at 230 Volts;
6,3AT (slow) in the 100 and 120 Volts models.
CAUTION: Replace fuses only against same type and rating!
Cooling: two fans each 12 Volts DC - 1,2 watts;
Please Note: To protect your amp from damage due to overheating, please ensure the cooling
fans remains in operation at all times, especially during lengthy gigs or other
occasions when your amp´s operating temperature is high.
For recording in the studio or other applications that demand absolutely silent
operation, you may disconnect the power supply to the fan pulling the central
power supply plug. Ensure the fan is not off for longer than two to three hours.
Dimensions: Combo E340: approx. 57,5 x 48 x 27 cm; Head E345: approx. 57,5 x 27 x 27 cm
( l x h x d )
Weight: Combo E340: approx. 24 kg; Head E345: approx. 18 kg;
Tube array:
V 5
V4
V 6 V 7 V 8
V3 V 2 V1
Chassis Type E340
and E345
power
transformer
output transformer
cable to the reverb spring,
red plug: Input
black plug: Output
cooling fan
connector
(40 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales